Shofu BeautiBond Light Cure Self Etching One Component Dental Adhesive6ml/BottleNew 7th-generation bonding agent has an exclusive chemistry with unique dual adhesive monomers that deliver equal bond strength to enamel and dentin.Effective Bonding to Any Restorative SurfaceBond strengths comparable to leading multi-component brandsSingle coat for shorter working timeEfficient 30 second application5μm film thicknessHEMA-freeMade in JapanOne StepAPPLICATIONBonding dental composite restorations to cavity and lesion areas including dentin surfacesDIRECTIONS FOR USE1. Clean the tooth surface following the conventional method.2. Prepare the cavity following the conventional method.3. Isolate with rubber dam etc following the conventional method.4. Cap the pulp with calcium hydroxide in areas where the remaining dentin is thin.5. Application of BeautiBond BottleDispense adequate amount of BeautiBond on a V-Dish and close the cap immediately after dispensing. Applyon the entire inner surface of the cavity using a Microtip Fine.6. Leave undisturbed for 10 sec. Air dry with gentle air for about 3 sec and then dry with stronger air until a thin anduniform bonding layer is obtained. (In cases where the tooth area being bonded is either mostly or entirely uncutenamel, apply an etchant on the enamel before application of the adhesive.)7. Light-cure with a dental curing light unit. Halogen (irradiation wave length: 400-500nm, light intensity: >500mW /cm^2): 10 sec, LED (irradiation wave length: 440-490nm, light intensity: >1,200mW / cm^2): 5sec.8. Filling, curing, contouring and polishing of light-cured dental filling composite resin: follow the compositemanufacturer’s directions for use.
